The majority of ball screw pair failures are caused by?reduced motion quality, excessive backlash, mechanical creep, and poor lubrication.?We?will?analyze the causes of different failure phenomena of ball screws and put forward corresponding solutions.
?
1.?High roughness value of processed parts
1)?The lubricating oil of the guide rail is not enough, causing the sliding plate to crawl
Method:?Add lubricating oil to eliminate lubrication failure
?2)?The ball screw is partially rough or damaged
Method:?Replace or repair ball screw
?3)?The screw bearing is damaged and the movement is not stable
Method:?Replace damaged bearings
?4)The servo motor is not adjusted well, and the gain is too large
Method:?Adjust the servo motor control system
?
2.?Large reverse error and unstable processing accuracy
1)?Loose cone sleeve of screw shaft coupling
Method:?Retighten and repeat the test with a dial indicator
2)?The screw?shaft slide plate is too tight or too loose with the pressure plate
Method:?Re-adjust or repair, use a 0.03mm ruler to be qualified
3)Screw shaft slide with wedge iron is too tight or too loose
Method:?Re-adjust or repair to make the contact rate reach over 70%
?
?
3.?Too large ?torque of the ball screws
1)?Two skateboards cooperate with the pressure plate too tightly or are damaged
Method:?Readjust or repair the pressure plate to make the 0.04mm caliper plug not qualified
2)?The ball screw nut reverser is damaged, the ball screw is stuck or the shaft end nut pretension is too large
Method:?Repair or replace the screw and adjust it carefully
3)?Servo motor and ball screw are connected to different shafts
Method:?Adjust the coaxial and tighten the connection seat
?
4.?Poor lubrication of screw nut
1)?Whether the oil separator divides the oil
Method:?Check the quantitative oil separator
2)?Whether the oil pipe is blocked
Method:?Remove dirt and make the tubing unblocked
?
5.?Ball screw noise
1)?The ball?screw bearing gland is not pressed properly
Method:?Adjust the gland to make it tight against the bearing
2)?Poor lubrication of ball screw
Method:?Check the oil separator and the oil circuit to make sure the oil is sufficient
?
September 27, 2024
October 18, 2024
Ball screws are essential components in medical devices, providing the precision and reliability necessary for various applications in healthcare technology. They convert rotational motion into lin
一、Tesla has achieved multiple innovative breakthroughs in the application technology of lead screws in the fields of automobiles and humanoid robots. In the automotive field, the application of ball...
The differences in the application of screw products between domestic new energy vehicles and Tesla vehicles: 一、Application 1. Domestic new energy vehicles: 1) Battery production and assembly: The...
Fault Diagnosis Methods and Technologies 1. Vibration Analysis Method 1) Vibration signal acquisition Collect the vibration signals of the linear motion ball screw pair through acceleration sensors...
Email to this supplier
September 27, 2024
October 18, 2024
Privacy statement: Your privacy is very important to Us. Our company promises not to disclose your personal information to any external company with out your explicit permission.
Fill in more information so that we can get in touch with you faster
Privacy statement: Your privacy is very important to Us. Our company promises not to disclose your personal information to any external company with out your explicit permission.
